Recommended
Shared Projects Questions Sponsorships Feedback Blog Like
Assembly are perfect
The thing that I found unique was I picked up a heatsink for this board, I want to choose the one that often be found on the raspberry pi CPU module, but since I can't find it so just one with about s...
Everything good, and the accelerometer sensor was working, no problem so far.
The assembly of my board was done perfectly by pcbway. Unfortunately the board not 100% working, there's an issue that I faced regarding the sensing of the battery by the charger IC. I should've follo...
This board also my first design that has a lot of components assembled not only in the top, but also a lot in the bottom side. When I got the board, I tested it, and actually everything were working. ...
Because there're a lot of parts in the BOM, and it was during this time I started to feel the impact of the pandemi, which is the shortage of component in supplier (Digikey and Mouser). Some of my par...
It's a small board with simple circuit and minimal component. No problem, no issue faced, thanks. Good job!
It's working perfectly, the only thing is there some remaining stain in the board not being cleaned, so i need to clean it myself upon receival.
This board is for controlling either dc motor, stepper, or to drive solenoid valve (coil). It's a 2 layer board with 2 oz copper finishing. One or two of the board that I received have some white stai...
Smallest board that I designed so far. Consisting of accelerometer sensor, some passive component, and an IDC connector.
It's a 2 layer board with 1 oz copper finishing. The board will contain two lithium ion battery, battery charger IC, and a sepic regulator, etc. The board has a lot of analog stuff on it. This board a...
This design was actually my first PCB which I pick a 2 oz copper finishing. Because in the circuit some trace might not be able to handle the current requirement, if it was only implemented with 1 oz ...
It's a general purpose microcontroller board with some connectivity like ethernet, USB, wifi (esp32). Also have eeprom on board and socket for micro sd card. Due to this many peripheral implemented on...
It's a small board with simple circuit and minimal component. No problem, no issue faced, thanks.
1 2 3