This stencil is definitely an essential part that is needed to assemble my new ESP32-S Dev Rev 2.0 PCB. The stencil is very well made, and accurate, allowing me to apply just the right amount of sol...
This is a tiny little experimental board that I designed to test out my MOSFET driver idea. It turned out exceptionally well, with the PBC working exactly as expected. The PCB is of very high qual...
The PCB is super high quality, as usual. Thank you. Silkscreen is crisp and easily readable. and the boards are free of defects and scratches. Since this is mostly a through-hole component board, ...
Good product and services
This is the second of these module that I have bought recently. This time , the quality seems much better than before, and it works perfectly. ( On the previous order, there was quite a lot of flux re...
Well made and accurate. Thank you
The Stencil is well made and accurate. Thank you
Well made and Accurate. An essential item to ensure that the PCB is correctly assembled. Thank you PCBWay
This is a hardware revision of an existing project of mine. I added some circuitry to make using the board a bit easier, as well as improved the routing and PCB Heatsink areas to handle the heat gener...
This is a continuation on a previous project, this time adding I2C to the mix to reduce the number of required IO lines to operate the keypad. Once again, the PCB is of super high quality, with a ...
Good product and services
Very support
Unfortunately I had to cancel this item, as there was an issue with stock. This caused a delay in shipping my main order, with PCB's that was on a tight schedule. PCBWay handled the issue very well, ...
This is the other part of the benchtop development tools for CAN Bus project design. This PCB can be used stand alone, of in conjunction with the ATMEGA4808 with CAN Bus DEv board. The PCB seems t...
Part of a set of Bench prototyping tools, This is an ATMEGA4808 development board with CAN bus support. The PCB seems to be of very high quality - The soldermask is neat and crisp - The PCB was se...
This is the next revision of a previous project, that will add stereo I2S support to an ESP32-s. The PCB was well made and seem to be super high quality. The assembled shield works perfectly. The ...
1 ... 10 11 12 13 14 15 16 17 18 19 20 ...