good
A prototype base-board for the Raspberry Pi Zero/ Zero W to address two issues that I have with using the Pi Zero W 1) Battery Backup: Although there are plenty of UPS hats available, I find the...
Well manufactured and accurate, thank you
Well manufactured and accurate, Thank you
Well manufactured and accurate. Thank you
good job
good job
Having a lot of SMD resistors in little plastic bags gets annoying after a while. I decided to use some beans and buy containers. It will surely help make my life a bit more organised, as well as add ...
Stencil to make SMD assembly a bit faster.
Good PCB quality. Working well. Thank you.
My latest, and hopefully last LoRa based project for a while... In this one, I basically replaced the logic converters with a dedicated chip, as well as added a buzzer output as well. The idea was tha...
Another one of my LoRa device projects, been having a lot of those lately:) This one has the need to have an onboard relay, as well as inputs for sensors on a single PCB. I also have the requirement t...
This is my attempt at fixing what I personally believe is a bad design. The Ra-02 breakout module, currently on sale, is a very basic, pin to header breakout, with very little else... Now, the Ra-02, ...
good job
Good job
A stencil to make SMD manufacturing of the CAN-BUS Relay Module a bit faster and easier. The stencil was well made and all footprints are correct. Thank you
1 ... 22 23 24 25 26 27 28 29 30 31 32 ...