DIY 8-bit computer
Ordered a PCB for the first time, for a DIY 8-bit computer project. I have to say, PCBway made the experience pretty easy, and I was very pleased with the results. I designed the board using Eagle, and uploaded the gerbers during the ordering process. I might try uploading the .brd file next time, as apparently this is supported. Perhaps this already exists, and I don't know about it, but it would be nice if PCBway had a set of design rules which could be loaded into Eagle to make preparing a PCB for manufacture easier. Over all, very happy and have ordered some more boards already!
May 02,2018
267 viewsReport item
- Comments(1)
- Likes(0)
You can only upload 1 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000