Raspberry Pi breakout connector
This board is used to connect the 40 pins from RPi2/3 power it with 5V (red led) and output 3.3V (yellow led) , debug led on pin 40. The goodnes of it is that you can draw 800mA of 3.3v regulator, polarity inversion protection, and flip over if board if you need led / connector / RPi
Step 1: How to use it
Board can be self soldered as required, screw connector can be placed on top or bottom layer.
Debug led can be enabled or disabled as desired by soldering or desoldering pin 40 bridge.
Power must be 5V and 3.3v is not related to RPi
Jun 01,2016
1,268 viewsReport item
- Comments(0)
- Likes(1)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
