Underwater 200A actuator controller

Stencil is fine - I got the polished holes, and the edges are nice and crisp. the hard part for me was deciding correct thickness since I have a mix of tiny pads and large pads, I also made a few mistakes Next time I will order a _framed_ stencil - It's possible but hard to use without a frame as the stencil lifts slightly when using which will smear small pads. If that happens you need to reprint otherwise shorts will develop. I had a couple through hole parts I'm also running through the oven at the same time but of course I left those off the stencil - so pay attention to your layout program! - I manually added paste to work with those, next time I will correct in layout. And save some shipping - and order the stencil with the PCB, I manually built my first board and it's a lot harder w/o a stencil. You will spend a lot of time clearing shorts