Recommended
Shared Projects Questions Sponsorships Feedback Blog Like
This is a small part for holding M3 hex nuts for bolting items onto a surface where this mount is attached. Works as intended.
This is a "modular" hinge that can be stacked into standard barrel hinge as seen on doors and works well for small models.
This is a small spoked detail about a centimeter across and it came out incredibly sharp.
This is a small spoked detail about a centimeter across and it came out incredibly sharp.
Small, cubic, hollow bins with 1.2mm thick walls that work as intended for holding small parts and liquids.
This is a ruler made form a PCB. I thought it was just a gimmick item, but it has useful markings for identifying many types of circuit board components. Along with a normal ruler, it also has holes f...
This is a scale model of a tank radiator. There are a few belts and pipes that are smaller than recommended sizing and I accepted deformation responsibility. Even so, they printed perfectly and I am q...
This is a perpendicular mount for an M3 bolt to be attached to any surface and works as intended.
This is a small spoked detail about a centimeter across and it came out incredibly sharp.
This is a small spoked detail about a centimeter across and it came out incredibly sharp.
This is a tiny spoked detail only millimeters across and it came out incredibly sharp.
I received this as a free gift with my order and is a simple display of the PCBWay brand. It is thick and sturdy and the clear plastic is defect free.
This is a custom model of a generic panel with slits. This falls outside of the recommended minimum of 1mm thickness, but it printed perfectly (probably because it is a simple planar design) and is ex...
This is a custom model of a vent with 0.8mm spacing. This falls outside of the recommended minimum of 1mm thickness, but it printed perfectly (probably because it is a simple planar design) and is exa...
1 2