It's a 2 layer board with 1 oz copper finishing. The board will contain two lithium ion battery, battery charger IC, and a sepic regulator, etc. The board has a lot of analog stuff on it. This board a...
It's a general purpose microcontroller board with some connectivity like ethernet, USB, wifi (esp32). Also have eeprom on board and socket for micro sd card. Due to this many peripheral implemented on...
It's a standard single layer board with some passive components and connectors (hence the name interface board). I'm not sure the different between surface finish with silver or gold (enig), but so fa...
It's a small board for interfacing purpose. It convert uart signal from mcu to rs-485 using a transceiver from maxim integrated. There's a pin to control the direction (switch) between sending or rece...
This is a general purpose microcontroller board with a lot of connector that interface the peripheral of the device to outside world (external boards). On this board there's a USB micro B connector th...
It's a external small board contain eeprom and flash memory, mean to connect to a controller board that doesn't have internal eeprom, or need more flash to store data.
It's a single layer board contain some passive components and connector (that's why the name interface board). It was actually to provide a standard connector interface between our MCU board and the p...
I am very satisfied with the work and the delivery time is very fast. I hope my second order is just as fast. Thanks.
This design was actually my first PCB which I pick a 2 oz copper finishing. Because in the circuit some trace might not be able to handle the current requirement, if it was only implemented with 1 oz ...
It's a small board with simple circuit and minimal component. No problem, no issue faced, thanks.
This is the third revision of my general purpose microcontroller board for use in the lab product in the company where I work. Actually no significant change from the second revision, only some parts ...
This is just standard interface board for RS-485 communication via 8p8c modular connector. I was actually making this prototype to test if it's going to work when the channel being parallel, also I wa...
It's the second revision of my microcontroller board that I used on the company where I work. Apparently, the downside of the device was it doesn't have pin for external battery to back up the interna...
It's the first revision of my general purpose microcontroller board that was designed for internal i/o control for laboratory products in the company where I work. On this revision I want to test the ...
It's a 2 layer general purpose microcontroller board. Just standard 1 oz copper 1.6mm thickness board, HASL lead free. I like that the green solder mask looks more shiny compared to PCB manufactured b...
Good Build !!
1 ... 18 19 20 21 22 23 24 25 26 27 28 ...