SMD Prototyping Board with 300-Hole Breadboarding Area

This is an attempt to fix a very irritating problem that I have. Designing something on a breadboard, and having to use a lot of breakouts, with lots of wires, or having only SMD versions of a certain component, and having to build spider circuits with more wires, spending more time tracing bad connections than actually designing... With this in mind, I decided to do an SMD breadboard, with plenty of space for SMD resistors, capacitors, diodes etc, as well as those pesky tiny transistors of fets... combined with a solderable 300-hold breadboard, with power rails, all with a proper ground plane on both sides of the board, to attempt to minimise interference.. Obviously, this is meant for a more mature prototype, since everything is soldered. PCBWay did a very nice job manufacturing the board, and it looks great. Thank you





Aug 25,2022
1,112 viewsReport item
Jean Redelinghuys MakerIoT2020 View Profile
  • Comments(0)
  • Likes(1)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000