Side Panels for robotic car project

This was an extremely challenging project, from a manufacturing point of view, as EASYEDA software seems to be quite limited in panel designs with different PCB's on one panel. The reason for the complexity is that both PCB are actually mirror images of each other, on the outside at least. The inside is a plain 555 timer LED flasher unit. PCBWay did an extremely good job, adding mousebites to the correct areas, adding siderails as needed, and keeping in touch with me during the entire process. In the end the PCB's came out very well. Only pity is that my measuring of the funny angles were off by a few degrees, and short by a few millimetres somewhere else... the panels does however still fit perfectly. Assembly was super easy, no stencil was required. Very well done, Thank you indeed