1.54inch 200x200 E-Ink Display Module
Description：
This is an E-Ink display module, 1.54inch, 200 x 200 resolution, with embedded controller, communicating via SPI interface, supports partial refresh. Due to the advantages like ultra low power consumption, wide viewing angle, great effect under sunlight, it is an ideal choice for applications such as shelf label, industrial instrument, and so on.
Features:
No backlight, keeps displaying last content for a long time even when power down
Ultra low power consumption, basically power is only required for refreshing
SPI interface, for connecting with controller boards like for Raspberry Pi/Arduino/Nucleo, etc.
Comes with development resources and manual (examples for Raspberry Pi/Arduino/STM32)
Specifications:
Operating voltage: 3.3V
Interface: 3-wire SPI, 4-wire SPI
Outline dimension: 48 x 33mm / 1.89 * 1.30in
Display size: 27.6 x 27.6mm / 10.09 * 10.0*in
Dot pitch: 0.138 x 0.138
Resolution: 200 x 200
Display color: black, white
Grey level: 2
Refresh power: 26.4mW(typ.)
Standby power:<0.017mW
Viewing angle: >170
VCC: 3.3V
GND: Ground
DIN SPI MOSI pin
CLK: SPI SCK pin
CS: SPI chip selection, low active
DC: Data/Command selection (high for data, low for command)
RST : External reset, low active
BUSY: Busy status output, low active
- Comments(0)
You might like
-
-20%
ESP32-C6 1.47inch Display Development Board, 172×320, 262K Color, 160MHz Running Frequency Single-core Processor, Supports WiFi 6 & Bluetooth, ESP32 With Display$12.00 or 1200 BeansRedeem Now -
ESP32-S3 1.47inch Display Development Board, 172×320, 262K Color, Up to 240MHz Frequency, Supports WiFi & Bluetooth, With Colorful RGB LED, ESP32 With Display$12.00 or 1200 BeansRedeem Now -
-11%
ESP32-S3 4.3inch Capacitive Touch Display Development Board, 800×480, 5-point Touch, 32-bit LX7 Dual-core Processor$32.00 or 3200 BeansRedeem Now -
ESP32-S3 1.69inch Display Development Board, 240MHz Dual-Core Processor, 240×280 Pixels, Supports WiFi/Bluetooth, Micro LCD Display With ESP32-S3$15.00 or 1500 BeansRedeem Now -
-
-
-
T-Display S3 AMOLED 2.0 soldered pin | Upgraded from an LCD to an AMOLED display, better color display$30.00 or 3000 BeansRedeem Now -
LILYGO T4-S3 ESP32-S3 2.41-inch AMOLED Touch Display Development Board RGB Screen Dual-Core LX7 Microprocessor WIFI Bluetooth$56.00 or 5600 BeansRedeem Now -
-
-19%
T-0.85 Inch LCD Module | GC9107 Full Color Display IPS 128*128 Screen Development Board$4.00 or 400 BeansRedeem Now -
-15%
LILYGO T-Display-S3 1.9-inch LCD display development board(Touch Version Non-Soldered Pin)$22.00 or 2200 BeansRedeem Now -
-3%
1.54inch NFC-Powered e-Paper, No Battery, Wireless Powering & Data Transfer$27.00 or 2700 BeansRedeem Now -
-22%
4.2inch NFC-Powered e-Paper Evaluation Kit, Wireless Powering & Data Transfer$70.00 or 7000 BeansRedeem Now -
-
Universal e-Paper Raw Panel Driver Board, ESP32 WiFi / Bluetooth Wireless$13.00 or 1300 BeansRedeem Now -
5.65inch ACeP 7-Color E-Paper E-Ink Raw Display, 600×448, without PCB$46.00 or 4600 BeansRedeem Now -
-23%
2.66inch E-Paper E-Ink Display Module (B), 296×152, Red / Black / White, SPI$13.00 or 1300 BeansRedeem Now -
2.9inch Touch E-Paper E-Ink Display HAT for Raspberry Pi, 5-Points Capacitive Touch, 296×128, Black / White, SPI$22.00 or 2200 BeansRedeem Now
1.54inch 200x200 E-Ink Display Module
In Stock
