2.8 inch SPI Touch Module ILI9341
Product Description：
- 2.8-inch color screen,support 65K color display,display rich colors
- 320X240 resolution, optional touch function
- Using the SPI serial bus, it only takes a few IOs to illuminate the display
- Easy to expand the experiment with SD card slot
- Provide a rich sample program
- Military-grade process standards, long-term stable work
- Provide underlying driver technical support
Product Parameters：
Display Color: RGB 65K color
SKU: MSP2807
Screen Size: 2.8(inch)
Type: TFT
Driver IC: ILI9341
Resolution: 320*240 (Pixel)
Module Interface: 4-wire SPI interface
Active Area (AA area): 43.2x57.6(mm)
Module PCB Size: 50.0x86.0(mm)
Operating Temperature: -20℃~60℃
Storage Temperature: -30℃~70℃
VCC power voltage: 3.3V~5V
Logic IO port voltage: 3.3V(TTL)
Power Consumption: TBD
Weight(Package containing): 43(g)
Interface Definition：
VCC: 5V/3.3V power input
GND: Ground
CS：LCD chip select signal, low level enable
RESET： LCD reset signal, low level reset
DC/RS： LCD register / data selection signal, high level: register, low level: data
SDI(MOSI)： SPI bus write data signal
SCK： SPI bus clock signal
LED： Backlight control, high level lighting, if not controlled, connect 3.3V always bright
SDO(MISO)： SPI bus read data signal
T_CLK： Touch SPI bus clock signal
T_CS ：Touch screen chip select signal, low level enable
T_DIN：Touch SPI bus input
T_DO：Touch SPI bus output
T_IRQ：Touch screen interrupt signal, low level when touch is detected
- Comments(0)
You might like
-
-20%
ESP32-C6 1.47inch Display Development Board, 172×320, 262K Color, 160MHz Running Frequency Single-core Processor, Supports WiFi 6 & Bluetooth, ESP32 With Display$12.00 or 1200 BeansRedeem Now -
ESP32-S3 1.47inch Display Development Board, 172×320, 262K Color, Up to 240MHz Frequency, Supports WiFi & Bluetooth, With Colorful RGB LED, ESP32 With Display$12.00 or 1200 BeansRedeem Now -
-11%
ESP32-S3 4.3inch Capacitive Touch Display Development Board, 800×480, 5-point Touch, 32-bit LX7 Dual-core Processor$32.00 or 3200 BeansRedeem Now -
ESP32-S3 1.69inch Display Development Board, 240MHz Dual-Core Processor, 240×280 Pixels, Supports WiFi/Bluetooth, Micro LCD Display With ESP32-S3$15.00 or 1500 BeansRedeem Now -
-
-
-
T-Display S3 AMOLED 2.0 soldered pin | Upgraded from an LCD to an AMOLED display, better color display$30.00 or 3000 BeansRedeem Now -
LILYGO T4-S3 ESP32-S3 2.41-inch AMOLED Touch Display Development Board RGB Screen Dual-Core LX7 Microprocessor WIFI Bluetooth$56.00 or 5600 BeansRedeem Now -
-
-19%
T-0.85 Inch LCD Module | GC9107 Full Color Display IPS 128*128 Screen Development Board$4.00 or 400 BeansRedeem Now -
-15%
LILYGO T-Display-S3 1.9-inch LCD display development board(Touch Version Non-Soldered Pin)$22.00 or 2200 BeansRedeem Now -
-3%
1.54inch NFC-Powered e-Paper, No Battery, Wireless Powering & Data Transfer$27.00 or 2700 BeansRedeem Now -
-22%
4.2inch NFC-Powered e-Paper Evaluation Kit, Wireless Powering & Data Transfer$70.00 or 7000 BeansRedeem Now -
-
Universal e-Paper Raw Panel Driver Board, ESP32 WiFi / Bluetooth Wireless$13.00 or 1300 BeansRedeem Now -
5.65inch ACeP 7-Color E-Paper E-Ink Raw Display, 600×448, without PCB$46.00 or 4600 BeansRedeem Now -
-23%
2.66inch E-Paper E-Ink Display Module (B), 296×152, Red / Black / White, SPI$13.00 or 1300 BeansRedeem Now -
2.9inch Touch E-Paper E-Ink Display HAT for Raspberry Pi, 5-Points Capacitive Touch, 296×128, Black / White, SPI$22.00 or 2200 BeansRedeem Now
2.8 inch SPI Touch Module ILI9341
-41%In Stock
