WiFi Deauther MonsterV3
WHAT IS IT
This ESP8266 development board comes with an integrated 18650 charging system, OLED display and a 3 way momentary slide switch?.
It comes installed with the latest ESP8266 Deauther software.
With this software, you can perform different attacks to test WiFi networks.
Please note that the ESP8266 does only support 2.4GHz. For more details on the software, visit:
github.com/spacehuhn/esp8266_deauther.
You can also use it to develop your own software. It is simple to use, just like any other ESP8266 development board.
GPIOS AND HARDWARE INFO
Display: SH1106 1.3" OLED
Display SDA: GPIO 5 (D1)
Display SCL/SCK: GPIO 4 (D2)
WS2812b LED: GPIO 15 (D8)
Button Up: GPIO 12
Button Down: GPIO 13
Button Select: GPIO 14
Breakout Pins:
GPIO-16
GPIO-3(RXD)
GPIO-1(TXD)
GPIO-5(SDA)
GPIO-4(SCL)
GPIO-0
GPIO-2
3.3V
GND
5V
WHY DID YOU MAKE IT
I designed this development board specially for Spacehuhn's great project: ESP8266 Deauther
It has been authorized by him and is officially supported.
Thanks to every customer that leaves feedback! I will keep improving this board.
WHAT MAKES IT SPECIAL
Only ~100mA power usage
Up to 35h of battery life with a 3500mAh 18650 cell
Included 8dB antenna and Arcylic case
4 LEDs to indicate battery status in real time
Reverse LED indicate wrong battery direction
Power button: Click to turn on, double click to turn off,long click will open high light LED
Protection: short, over charging, over discharging, temperature,polarity
Break out GPIOs of ESP8266
DISCLAIMER
Use it only for testing and educational purposes against your own devices!
I don't take responsibility for what you do with it.
Please check the legal regulations for your country to make sure you don't violate any laws.
DSTIKE Boards - Comments(0)
Log in to post comments.
You might like
WiFi Deauther MonsterV3
Out of stock
