All features are within 0.4mm of spec. Arrived slightly wrapped. Due to a design error, the well in the center is too shallow for the 100mm Petri dish to sit in.
Display bezel made from UTR8220 Resin, with inserts. I'm highly satisfyed with the quality and a bit surprised, how stiff that material is. I painted it black with Acrylic paint.
The part has good quality! Shipping time were in time! I'm very happy with the order and I will sure buy again for future parts and projects!
The part has good quality! Shipping time were in time! I'm very happy with the order and I will sure buy again for future parts and projects!
Very fast and professional. Perfect quality. Thanks PCBW, well done.
отлично получилось, минимальная обработка до товарного вида, настоящая нержавейка, прочность сомнений не вызывает
This was my first 3D Design for my electronic board. Thanks to PCBway I found the right material and I can redesign some too small details before the manufacturing starts. The case looks good and the ...
The tenon is about 0.3mm too narrow, resulting a poor fit over the holding ring. The bottom of the tenon fall off the mortise on the holding ring for about 1.6mm. The cut out on the other end for the ...
A small part to test the viability of SLM printing working parts in aluminum with post machining similar to casting. Print was exceptional quality and within tolerance. Part was solid without any poro...
Custom (Game Boy) Pocket Camera Shell, looks fine. Good Quality. works fine
The part has good quality! Shipping time were in time! I'm very happy with the order and I will sure buy again for future parts and projects!
Excellent,however It jade a litlle dimensional deformation,bit nothing that disturbs. Thx
Very satisfied with the outcome! The distortion is minimal. Small features are very well reproduced. The mating surfaces function flawlessly. The module 1.0 helical gears mesh smoothly. One minor iss...
In essence the outcome is good. But the unit is warped from one corner to the diagonal. See attachment. The lower right corner of the unit is not touching the surface and so as the diagonal corner ...
So this is a case for the bakeneko60 keyboard essentially and it turned out to be a lot better than I expected. I got this 3d printed just to test out the tolerances of the case before I'm gonna get i...
The 3D print turned out pretty well! Both the internal and external threads fit perfectly. The vacuum seal the adapter and the bottle created is sufficient to run a 0.22 micron bacterial filter. The t...
1 2 3 4 5 6 7 8 9 10 11 12 ...