|
TinkerCad |
Hologic Compression Motor Gear
This replaces the stock gear in Hologic compression motors. The stock ones are a 2 piece shaft and gear design that are booger welded together and break easily.
I have notified the manufacturer many times to no avail about this issue so I decided to fix it myself.
Has been bench tested when printed in stainless steel. I would not reccomend plastic but a nylon may also work.
Has not been tested for longevity but can say so far it stands up much better than the original.
If you know anything about Hologic compression motors, you know how hard they are to replace and this may make that a thing of the past.
May not work with new style motors, have not tested.
As this is for a medical device, use at YOUR OWN RISK.
Hologic Compression Motor Gear
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(0)
More by Engineer
-
-
-
kmMiniSchield MIDI I/O - IN/OUT/THROUGH MIDI extension for kmMidiMini
118 0 0 -
DIY Laser Power Meter with Arduino
170 0 2 -
-
Box & Bolt, 3D Printed Cardboard Crafting Tools
157 0 2
