|
Autodesk Fusion 360Autodesk
|
Polaroid Super Shooter 120 6X6 cartridge and back
This back and cartridge will fit onto a Polaroid Super Shooter and other plastic bodied Polaroid cameras.
To use this back, remove the old back and the wire retainer and put the retainer onto the new back. Remove the black cover over the left side of the cartridge bay. This cover is there so that the film pack will slide in, actuating the switch at the upper left. Because it won't be there anymore, be sure you slide the 120 6x6 cartridge in the same way as before, otherwise it will sit on top of the switch. It needs to slide in so it rests against the switch.
Polaroid Super Shooter 120 6X6 cartridge and back
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(0)
More by Jim Skelton
-
Polaroid 35mm panorama cartridge and back
This is a cartridge and back for Polaroid pack film cameras models 100-455 which enables it to shoot...
-
Polaroid Super Shooter 120 6X6 cartridge and back
This back and cartridge will fit onto a Polaroid Super Shooter and other plastic bodied Polaroid cam...
-
Polaroid 120 6x6 cartridge and back
This is a 120 cartridge which fits into a Polaroid pack film camera (Models 100 - 455) so it can use...
-
Polaroid 120 6x9 cartridge and back
This is a cartridge and back which fits onto/into a Polaroid pack film camera (models 100-455) so it...
-
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
154 1 1 -
-
