|
KiCADKicad
|
Light Sensor
This device can be used to measure the current light intensity on a scale of one to ten which is displayed on the seven segment display. When the on switch is pressed the analog reading is taken from the light sensor by the ADC pin. The value is calculated on a one to ten scale and displayed for three seconds. The code makes use of micropython which initializes the pins and runs the code functions. It is planned to communicate the result over serial connection. The use cases could comprise solar panel testing and agricultural / growing uses.
Light Sensor
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
ESP32-S3 4.3inch Capacitive Touch Display Development Board, 800×480, 5-point Touch, 32-bit LX7 Dual-core Processor
BUY NOW
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(1)
- Likes(0)
Log in to post comments.
Reply
More by Engineer
-
-
-
Modifying a Hotplate to a Reflow Solder Station
745 1 5 -
MPL3115A2 Barometric Pressure, Altitude, and Temperature Sensor
402 0 1 -
-
-
V2 Commodore AMIGA USB-C Power Sink Delivery High Efficiency Supply Triple Output 5V ±12V OLED display ATARI compatible shark 100W
961 4 2 -
How to measure weight with Load Cell and HX711
636 0 3
