1. Blog>
  2. PCB shorted improvement measures

PCB shorted improvement measures

by: Feb 19,2014 1147 Views 0 Comments Posted in Engineering Technical

PCB manufacturers PCB

PCB " short circuit " is a question of each PCB manufacturers will encounter almost every day , and it is a difficult problem , improve the well or bad this problem is directly related to the cost of production is low or high , the pass rate is also related to the finished product problems.

Now the reasons causing these phenomena individually analyzing and improving methods listed below:

First, run a short circuit caused by tin

1, in the back caused by improper operation of the membrane tank ran syrup tin ;

2 , the film has been retired due to run tin plates stacked together .

Improvement:

( 1 ) . Stripping syrup high concentrations , retired film for a long time , anti- plating has already dropped, board still alkaline solution to soak , some tin foil attached to the surface of the powder , a metal tin guarding a thin copper surface etching , played the role of corrosion , resulting in the removal of copper is not in addition to clean, leading to short-circuit . So we need to strictly control the concentration of membrane syrup retreat , temperature, film back time and time back flapper film frame plugged in, not laminated together between the board and the board touch .

( 2 ) the back sheet film drying will not superimposed together such immersion tin plate between the plate and the film was not dried back , some of the tin layer on the copper foil attached to the surface is dissolved when etching a a thin layer of metallic tin patrol copper surface , play a role in corrosion , resulting in the removal of copper is not in addition to clean, leading to short-circuit .

Second, the net result of a short circuit is not etched

An etching solution parameter control directly affects the quality of the etching , the current Division I use alkaline etching solution , specifically as follows :

1.1 PH value: 8.3 to 8.8 between the control , if the PH value is low , the solution becomes a viscous state, color whitish , Etching rate decreased , this likely to cause side etching is controlled primarily by adding ammonia PH value.

1.2 chloride ions: controlled between 190 ~ 210g / L, chlorine ion content mainly controlled by the etching salts, ammonium salts are etched and supplements thereof.

1.3 Specific Gravity: primarily by controlling the content of copper ions for control of the proportion of the general control of the copper ion content between 145 ~ 155g / L, each producing about an hour once for testing in order to ensure the stability of gravity .

1.4 Temperature : Control at 48 ~ 52 ℃, if the temperature is high ammonia volatilization fast, the pH will cause instability and cylinder etching machine are mostly made ​​from PVC material , PVC temperature limit is 55 ℃, Above this temperature is likely to cause cylinder distortion, and even cause etching machine scrapped , it must be installed with an automatic thermostat temperature for effective monitoring to ensure that within its control in .

Join us
Wanna be a dedicated PCBWay writer? We definately look forward to having you with us.
  • Comments(0)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
    Back to top