USB isolator/USB to USB isolator digital signal audio power isolator ADuM3160
Product parameter:
- Compatible with USB2.0
- ADUM3160 isolation voltage: 2500V
- Isolation voltage of power module: 1500V
- USB full speed 12Mbps is supported. Pure high-speed devices are not supported
- Support USB control transmission, batch transmission, interrupt transmission, synchronous/isochronous transmission.
- Power supply: from the USB port of the computer host.
- Drive-free, more convenient to use
- Operating environment: -40℃ to 85℃
Tested and supported devices:
Full speed equipment:
USB flash drive, digital camera, card reader, mobile hard disk, U shield, USB hub, AVRJTAG, AVRISP, AVRISPMKII, S-Lab, JET51, J-Link, FET430UIF, PICKIT2, XDS100, LPC-Link, ICD2, USB to serial port (FT232, CP2102)
Unsupported equipment:
USB wireless network card, partial USB3.0 U-disk after testing
Attention:
The on-board output power supply of this product, Jinshengyang B0505S, has a power of 1W. When the working current of your USB device is more than 180mA, you can use USB double-headed wires to supply power.
This product supports full-speed devices, but does not support pure high-speed devices (USB2.0). Most USB devices backwards compatibility can be used.
- Comments(0)
You might like
-
-24%PCBWay Single-Channel Relay Module with Delayed Power-off, Triggered Delay, and Cyclical Timing Circuit Switch$1.50 or 150 BeansRedeem Now
-
-
Four Way Holder V3 Development Board(Compatible with Raspberry Pi/STM32)$9.00 or 900 BeansRedeem Now
-
-
-50%1 Channel Relay Module 5V with optocoupler Support High and Low Level Trigger$1.00 or 100 BeansRedeem Now
-
Relay Module Interface Boards for Arduino Low Level Trigger 5V 2 Channels$2.00 or 200 BeansRedeem Now
-
-
LM2596S DC-DC 3A Buck Adjustable Step-down Power Supply Converter Module$1.00 or 100 BeansRedeem Now
-
-
-
-
Step-Down & Step-Up Converter DC-DC 1.8V-5V 3V 3.7V to 3.3V Power Module$1.00 or 100 BeansRedeem Now