L298N PWM Stepper Motor Drive Controller Board Module
Description:
This L298N-based driver module is a high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepping motors from 5V to 35V. It can easily control the DC motor speed and direction, and can also control 2-phase stepper motors. It can be used for other projects such as driving the brightness of certain lighting projects such as high powered LED arrays using Pulse Width Modulation (PWM) control.
Two enable inputs are provided to enable or disable the device independently of the input signals.
The module includes an onboard 5V regulator. When enabled by the jumper, the 5V is provided as an output on the power connector, and can be used as a 5V DC supply for your other circuit components. (When enabled, the module input voltage must be at least 6V). When disabled, a separate 5V input provides in order to control the logic level circuitry of this module.
Controller Parameters:
Driver chip: L298N dual H-bridge driver
Drive Voltage: +5V to +35V (Input voltage must be at least 6V when internal 5V regulator is enabled)
Drive peak current Io: 2A / Bridge
Logic power supply range Vss : +4V to +5.5V DC (Not required when internal regulator is enabled. When enabled, the 5V is available as an output on the power connector
Control signal input voltage range: 4.5-5.5V high 0V low
Maximum power consumption: 20W
Storage temperature: -25 ~ +130 C
Dimensions (approx): 43mm x 43mm x 27mm LxWxH (1.7" x 1.7" x 1.1")
- Comments(1)
You might like
-
-24%
PCBWay Single-Channel Relay Module with Delayed Power-off, Triggered Delay, and Cyclical Timing Circuit Switch$1.50 or 150 BeansRedeem Now -
-
Four Way Holder V3 Development Board（Compatible with Raspberry Pi/STM32)$9.00 or 900 BeansRedeem Now -
-
-50%
1 Channel Relay Module 5V with optocoupler Support High and Low Level Trigger$1.00 or 100 BeansRedeem Now -
Relay Module Interface Boards for Arduino Low Level Trigger 5V 2 Channels$2.00 or 200 BeansRedeem Now -
-
LM2596S DC-DC 3A Buck Adjustable Step-down Power Supply Converter Module$1.00 or 100 BeansRedeem Now -
-
-
-
Step-Down & Step-Up Converter DC-DC 1.8V-5V 3V 3.7V to 3.3V Power Module$1.00 or 100 BeansRedeem Now
L298N PWM Stepper Motor Drive Controller Board Module
-60%In Stock
