Recommended
Shared Projects Questions Sponsorships Feedback Blog Like
I needed a converter to boost consumer level RCA interface to professional level differential/XLR signal levels. This small PCB does that. The PCB is only 2 layers and includes SMT and through-hole pa...
This PCB required fabrication of two separate 4-layer designs then lamination of those back-to-back. It uses a high-performance material (Megtron) and includes blind vias and filled through-vias. The ...
This is the first stencil I have ordered without the frame. Since I have fiducials on the corners of this small PCB, this is working out quite well.
This is a test DIMM for evaluating DDR5 Registered DIMM data buffers and register chips. The effort included fabricating the 12-layer PCBs (in an array) and assembling the parts (double sided). On in...
PCIe Gen 5 x8 test fixture boards - fabricated quickly and delivered on time. I went with a tin finish rather than gold/ENIG to get the parts in-house quicker and these are very limited use, so the fi...
This is a small, 2-sided, flex (Kapton) design used to make a probe for feeding differential signals into an oscilloscope. The parts were panelized by PCBWay (9 per panel) so we received over 100 prob...
This is a test DIMM for evaluating DDR5 Registered DIMM data buffers and register chips. The effort included fabricating the 12-layer PCBs (in an array) and assembling the parts (double sided). After ...
Ordered quickly and received prototypes for mechanical fit check and initial marketing units to support customer review/audit of the project. We are very happy with the results on this quick-turn proj...