I am working on a sheet metal project that has three separate parts. The parts are designed in Fusion360 using the sheet metal toolbar. I am new to this design process and have a few questions to make...
Greetings. I have a request to make: can you produce a board based on the schematics I provide? Every component - resistor and capacitor are of SMD 0805 sizeActual values of resistors and capacitors c...
I need to place an SMA connector on the side of my board, but I am unclear how PCBWay would deal with a pad being placed that close to the side of the board. (They specify it should not be less than 0...
Hi I saw a Bob Beck electrifier here...https://www.pcbway.com/project/share/Zapper_Bob_Beck_beccfc49.html. I would like to order 5 of themRegards Franck
Hi, i like to create a board for my esp32 devkit edrums project.I like to have 12 input for the piezo pads, every input will be connected with 1M ohm resistor and a zener diode in parallel mode and ev...
I have an old piece of heavy equipment. A control board on it has gone bad that is no longer made. Is it possible to send this in to PCB way and have the board replicated?
