12-24V DC Power Supply for mmWave Sensors
A replacement power supply for the 24 or 5.8 GHz mmWave Radar Sensors on Aliexpress, described as "ZigBee3.0/Wifi 24G MmWave Radar Human Presence Motion Sensor For Light Switch Luminosity Detection 110/220V Tuya Smart Life Home"
https://s.click.aliexpress.com/e/_DlhAlq9
This will allow you to power the device from a DC supply at 12 or 24V if it suits your application a little better. There is an optocoupler output that can be used to drive relays, contactors or other devices, or you can just use the Zigbee output for automation with Home Assistant.
12-24V DC Power Supply for mmWave Sensors
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(3)
More by Steven Gardner
-
ESP32 DIN Rail RS485, Modbus and RGB LED Controller
A PCB layout designed to fit inside a CamdenBoss CNMB-2-2 DIN rail enclosure. Has a 5 to 35V input v...
-
Solder Test PCB
This is a test PCB that can be used to:Evaluate the performance of various types of solder wireLearn...
-
12-24V DC Power Supply for mmWave Sensors
A replacement power supply for the 24 or 5.8 GHz mmWave Radar Sensors on Aliexpress, described as "Z...
-
2835 Custom LED Strips (11mm Width)
High brightness custom LED strips in a 1x6 PCB panel - Industry standard 11mm wide, 140mm length.
-
High Efficiency Full Bridge Rectifier Demo Boards
This demonstration board is ideal to show the difference between a standard bridge rectifier and the...
-
-
-
kmMiniSchield MIDI I/O - IN/OUT/THROUGH MIDI extension for kmMidiMini
123 0 0 -
DIY Laser Power Meter with Arduino
172 0 2 -
-
Box & Bolt, 3D Printed Cardboard Crafting Tools
162 0 2
