|
|
ADRF5040ANALOG DEVICES
|
x 1 | |
|
|
100 pF capacitors, 0402 package |
x 2 | |
|
|
PC mount SMA RF connectors |
x 5 | |
|
|
Through hole mount test points |
x 5 |
ADRF5040 Evaluation Board
The ADRF5040-EVALZ is a fully populated, 4-layer, RO4350 based evaluation board. Two power supply of +3.3 V and -3.3 V should be applied to the VDD and VSS test points respectively while ground reference is connected to the GND test point.
Two control voltages of 0/+3.3 V that select the switch state are applied to the V1 and V2 test points. The RF input signal can be applied to the PC mount SMA RF connector labeled RFC and the RF output signals can be measured on the PC mount SMA RF connectors labeled RF1, RF2, RF3 and RF4.
https://www.analog.com/en/design-center/evaluation-hardware-and-software/evaluation-boards-kits/EVAL-ADRF5040.html
ADRF5040 Evaluation Board
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(0)
More by Engineer
-
MPL3115A2 Barometric Pressure, Altitude, and Temperature Sensor
46 0 0 -
-
-
V2 Commodore AMIGA USB-C Power Sink Delivery High Efficiency Supply Triple Output 5V ±12V OLED display ATARI compatible shark 100W
261 4 1 -
How to measure weight with Load Cell and HX711
375 0 3 -
-
Instrumentation Input, high impedance with 16 bit 1MSPS ADC for SPI
504 0 0
