|
|
C2 [100nf] |
x 1 | |
|
|
R1 |
x 2 |
CSI to HDMI Cable Extension Module
The CSI to HDMI adapter board is designed for V1 and V2 Raspberry pi camera board to extend the camera over the long cables while keeping the high-speed CSI signals away from noise and interference.
By using high speed HDMI cable, the camera can run over 10 meters, that high extend the usage of the Raspberry pi cameras.
This is a kit to use a standard HDMI cable between the Raspberry Pi and its camera. The biggest advantages are obviously the range increase, the possibility to use widely available cables, and to use a round and sturdy HDMI cable instead of a flat ribbon.
Note: You need a pair to use.
CSI to HDMI Cable Extension Module
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
ESP32-S3 4.3inch Capacitive Touch Display Development Board, 800×480, 5-point Touch, 32-bit LX7 Dual-core Processor
BUY NOW
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(3)
- Likes(0)
More by idreams
-
-
-
Modifying a Hotplate to a Reflow Solder Station
840 1 5 -
MPL3115A2 Barometric Pressure, Altitude, and Temperature Sensor
440 0 1 -
-
-
V2 Commodore AMIGA USB-C Power Sink Delivery High Efficiency Supply Triple Output 5V ±12V OLED display ATARI compatible shark 100W
1079 4 2 -
How to measure weight with Load Cell and HX711
686 0 3
Also, that version uses the correct part for the CSI connector, which should be a Molex 522711579 (https://www.molex.com/en-us/products/part-detail/522711579)