|
|
GAL16V8B |
x 1 | |
|
|
diode in DO-35 form factor |
x 6 | |
|
|
5.6 kΩ resistor |
x 1 | |
|
|
IC socket 20 pin |
x 1 | |
|
|
Male round pin header 14 pin |
x 2 |
Commodore TED series (16/116/Plus4) PLA replacement
This project is about a PLA replacement for the Commodore TED series computers, such as the C16/C116 and Plus/4.
Did you like the PLA20V8 PLA replacement for the Commodore 64? I have designed a GAL PLA for the TED series as well and it consists of just a single GAL16V8.
GALs are available at very low cost on popular internet marketplaces can be programmed using the popular TL866 EPROM programmer. They are DIP devices and can therefore be soldered by novice solderers. A PCB is needed that wires the GAL in the correct way and for that you have come to the right place.
The required fusemaps and more information is available here:
http://www.freepascal.org/~daniel/c16pla/
Recommended manufacturing options:
- Thickness: 1.0mm
- Surface finnish: HASL lead-free
- Solder mask colour: Black
- If you order a panel, route-process: V-scoring
- For all other options, please select the defaults
Commodore TED series (16/116/Plus4) PLA replacement
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
ESP32-S3 4.3inch Capacitive Touch Display Development Board, 800×480, 5-point Touch, 32-bit LX7 Dual-core Processor
BUY NOW
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(2)
- Likes(20)
Log in to post comments.
Reply
More by Daniël Mantione
-
MOS 8501 CPU replacement
The 6502to8501 is a device that allows you to use a 6502 CPU in your Commodore TED series computer, ...
-
EasyFlash 1CR cartridge (wide sram)
Many modern Commodore 64 games and releases use the Easyflash format and the software is distributed...
-
EasyFlash 1CR cartridge (narrow sram)
Many modern Commodore 64 games and releases use the Easyflash format and the software is distributed...
-
Commodore TED series (16/116/Plus4) PLA replacement
This project is about a PLA replacement for the Commodore TED series computers, such as the C16/C116...
-
Commodore 64 PLA replacement
This project is about a Commodore PLA replacement.PLA replacements for the Commodore 64 are availabl...
-
-
-
Commodore 64 1541-II 1581 Floppy Disk Drive C64 Power Supply Unit USB-C 5V 12V DIN connector 5.25
458 1 4 -
-
-
-
-
-
-
Modifying a Hotplate to a Reflow Solder Station
1308 1 6 -
MPL3115A2 Barometric Pressure, Altitude, and Temperature Sensor
737 0 1
