Description
GBA Cartridge Slot FFC Extender (Start)
Just a simple board which allows you to extend your GBA’s cartridge slot to another PCB by using a 32 pin FFC. You could have it work with Gameboy games if you apply some glue to the GBA cart to trigger GB mode.
Should be ordered as 0.8mm
No warranty and no help
Start: https://www.pcbway.com/project/shareproject/GBA_Cartridge_Slot_FFC_Extender_End_e1913275.html
End: https://www.pcbway.com/project/shareproject/GBA_Cartridge_Slot_FFC_Extender_Start_3520d0e1.html
Dec 12,2021
2,041 views
GBA Cartridge Slot FFC Extender (Start)
2041
1
0
Published: Dec 12,2021
PCBWay Donate 10% cost To Author
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Under the
Attribution-NonCommercial (CC BY-NC)
License.
Topic
- Comments(0)
- Likes(1)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
More by AlexiG
-
Gameboy 32KB Flash Cart
A 32KB Flash cart for the Gameboy. Order as 0.8mm and ENIG surface finish
-
Gameboy Debug Cart
A simple Gameboy debug cart, order as 0.8mm
-
GBA Cart Extender for aPocket
This should allow you to extend your GBA games to be flush with the Analogue Pocket top. Useful for ...
-
GBA Cartridge Slot FFC Extender (End)
Just a simple board which allows you to extend your GBA’s cartridge slot to another PCB by using a 3...
-
GBA Cartridge Slot FFC Extender (Start)
Just a simple board which allows you to extend your GBA’s cartridge slot to another PCB by using a 3...
-
GB 32KB XMAS Flash Cart
A Gameboy 32KB XMAS based flash cart. Uses a binary counter to animate the LEDs depending on the bri...
You may also like
-
-
-
kmMiniSchield MIDI I/O - IN/OUT/THROUGH MIDI extension for kmMidiMini
111 0 0 -
DIY Laser Power Meter with Arduino
162 0 2 -
-
Box & Bolt, 3D Printed Cardboard Crafting Tools
154 0 2 -
A DIY Soldering Station Perfect for Learning (Floppy Soldering Station 3.0)
554 0 2
