Mar 01,2024
3,380 views
end-flag
  • Comments(3)
  • Likes(8)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
  • Hi Thank you for sharing this nice project. The top stl for the Dial is missing could you please include it ?

    Reply
  • Unfortunately, the space/clearance around the hex nut is much too small. The hex nut on the bottom side will intercept with the two SMD resistors and the not-covered vias. You use the top and bottom solder resist to isolate the hex nut from your PCB traces. This is not good. A huge design fail, if you ask me.

    Reply
  • Si, am ur follower, u r doing very good job sir. Thanks a lot

    Reply
VOTING 0 votes
  • 0 USER VOTES
0.00
  • YOUR VOTE 0.00 0.00
You may also like