Propeller for E-foil / ASSIST
Print 1 hub and 3 blades. Design for 8-12S battery
Recommended for hub : PA-12 SLS (good) / HP-PA-12 MJF (best)
Recommended for baldes : Glass fiber nylon(PA12+35% GF) SLS (good) / Aluminum (AlSi10Mg) (best)
Fits motors =
- 6374, 6384 from aliexpress BDUAV store
- 6374, 6384 from saite
The three blade is foldable and has very good surface piercing capability, best for assist.
Need :
- 4x CHC M4x10 stainless steel
- 3x CHC M4x35 or 40 stainless steel (35 is slightly short for stop nuts)
- 3x Stop nut M4 stainless steel
Be careful, those propellers are sharp and can cut skin and fingers!!
Full build log :
https://foil.zone/t/light-assist-season-2
How does it work in a full project?
see : https://www.instagram.com/reel/DCe6M7qCqsq/?utm_source=ig_web_copy_link
Propeller for E-foil / ASSIST
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
ESP32-S3 4.3inch Capacitive Touch Display Development Board, 800×480, 5-point Touch, 32-bit LX7 Dual-core Processor
BUY NOW
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(0)
- Likes(0)
Log in to post comments.
More by adam Mercier
-
-
Commodore 64 1541-II 1581 Floppy Disk Drive C64 Power Supply Unit USB-C 5V 12V DIN connector 5.25
315 1 3 -
Easy to print simple stacking organizer with drawers
113 0 0 -
-
-
-
-
-
Modifying a Hotplate to a Reflow Solder Station
1211 1 6 -
MPL3115A2 Barometric Pressure, Altitude, and Temperature Sensor
691 0 1 -
