New Ethernet W5100 Network Expansion Board Module with SD Card Expansion, Compatible with UNO R3
Description
The Arduino-compatible Ethernet Shield allows an Arduino board to connect to the internet. It is based on the Wiznet W5100ethernet chip . The Wiznet W5100 provides a network (IP) stack capable of both TCP and UDP. It supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield. The ethernet shield connects to an Arduino board using long wire-wrap headers which extend through the shield. This keeps the pin layout intact and allows another shield to be stacked on top.
The Ethernet Shield has a standard RJ-45 connection, with an integrated line transformer and Power over Ethernet enabled.
There is an onboard micro-SD card slot, which can be used to store files for serving over the network. It is compatible with the Arduino, Crowduino and Mega (using the Ethernet library). The onboard microSD card reader is accessible through the SD Library. When working with this library, SS is on Pin 4.
Specification
- Operating voltage 5V (supplied from the Arduino-compatible Board)
- Ethernet Controller: W5100 with internal 16K buffer
- Connection speed: 10/100Mb
- Connection with Arduino-compatible on SPI port
- The Shield contains several informational LEDs
- PWR: indicates that the board and shield are powered
- LINK: indicates the presence of a network link and flashes when the shield transmits or receives data
- FULLD: indicates that the network connection is full duplex
- 100M: indicates the presence of a 100 Mb/s network connection (as opposed to 10 Mb/s)
- RX: flashes when the shield receives data
- TX: flashes when the shield sends data
- TX: flashes when the shield sends data
- COLL: flashes when network collisions are detected
code：
- Comments(0)
You might like
-
-
R7FA4 PLUS A Development Board, Based on R7FA4M1AB3CFM, Compatible with Arduino UNO R4 Minima$15.00 or 1500 BeansRedeem Now -
R7FA4 PLUS B Development Board, Based on R7FA4M1AB3CFM ,Equipped with ESP32-S3FN8, Compatible with Arduino UNO R4 WiFi$23.00 or 2300 BeansRedeem Now -
ESP32-S3-Nano Development Board, Based on ESP32-S3R8, Compatible with Arduino Nano ESP32$10.00 or 1000 BeansRedeem Now -
ESP32-S3-Nano Development Board, Based on ESP32-S3R8, Compatible with Arduino Nano ESP32$9.00 or 900 BeansRedeem Now -
-
-
-
-
-
-
-50%
New Ethernet W5100 Network Expansion Board Module with SD Card Expansion, Compatible with UNO R3$6.00 or 600 BeansRedeem Now
-
Mini MP3 Player Module with Simplified Output Speaker U-disk TF SD for Arduino$3.00 or 300 BeansRedeem Now -
-
-57%
-
ProtoShield Prototype Expansion Board with Mini Breadboard for Arduino UNO$2.00 or 200 BeansRedeem Now
New Ethernet W5100 Network Expansion Board Module with SD Card Expansion, Compatible with UNO R3
-50%In Stock
