2answers

[PCB Design] RF PCB design

I need a 6 layer PCB stackup with a low loss dielectricum to the top layer.Can you change the top dielectricum of your normal 6 layer 1.6mm stackup to RO4350 0.101mm?Do you suggest a nother stackup?If...
2answers

[PCB Prototype] RF PCB Stackup

Hello,I am desiging a 4-layer RF board with 50 ohm impedence control for RF signals. I need the following information from pcbway before I finish up the layout and submit the order: 1) What...
1answers

[Others] Should I connect isolated areas of ground pour?

As it shows, there are two isolated areas of the ground pour. I'm using Eagle, so when I do the pour it does not place in these type of areas unless I explicitly place a via where the bottom...
Ranking Name Answers
1 PCBWay Team 13
2 Engineer 1
3 Engineer 1
4 Tim Keiper 1
5 Engineer 1