ATTiny85 Breakout
I wanted to make some Neopixel light bars for the grand kids but didn't want to mess with proto boards so I figured I'd try to get a circuit board made. After trying several horrible programs recommended on the internet I finally got one to work(I have since found a great one). While laying out the project I figured that by adding a few more pads I could bring out all the pins from the ATTiny and use the same board for many projects. I ended up ordering 15 panels with 84 boards per panel, because they were so cheap, so now I have more than I will ever use at about 9 cents each. As you can see in the last picture that they worked for the project I originally wanted to make and I am working on more ways to use these little gems.
ATTiny85 Breakout
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(0)
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Ralph Price
- ATTINY85 Neopixel Driver I needed to fit a driver for some Neopixels into a tight space. This board when populated is smalle...
- Arduino Nano ATTiny Programmer Shield Add a couple sockets and headers, plug in an Arduino Nano and a 8 pin or 16 pin ATTiny 84/85 and pro...
- ATTiny85 Breakout I wanted to make some Neopixel light bars for the grand kids but didn't want to mess with proto boar...
- Tiny85 breakout While working on a Neopixels project for the grand kids I came up with this design to hold an ATTiny...
-
-
Helium IoT Network Sensor Development board | H2S-Dev V1.2
130 0 0 -
-
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
187 1 1