John John Vu
UKRAINE • + Follow
Feb 17,2021
2,904 views
end-flag

AVR Fusebit Doctor

2904
11
7
5.00 (1)
Published: Feb 17,2021
Add to cart

*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.

Copy this HTML into your page to embed a link to order this shared project
Copy
Copyright Info

Attribution-ShareAlike (CC BY-SA) License

Read More⇒
Under the Attribution-ShareAlike (CC BY-SA) License.
gift
Smart Soldering Iron TS101-BC2
BUY NOW
gift
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
gift
ESP32-S3 4.3inch Capacitive Touch Display Development Board, 800×480, 5-point Touch, 32-bit LX7 Dual-core Processor
BUY NOW
gift
MHP50-B5 Mini Hot Plate Preheater
BUY NOW
gift
Smart Soldering Iron TS101-BC2
BUY NOW
gift
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
Topic
Misc
Fusebit Doctor AVR
  • Comments(7)
  • Likes(11)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000

  • Hi, what capacity should be C9, C5? And R37, R4, R39, R38 It would be best if you send the whole BOM, because I see the board under version 2.10 and the schematic 1.10

    Dec 08,20221 Comments
    John John Vu 2022-12-09 04:17:19Reply

    C5 - 0.1u smd0805, C9 - 10u, R4, R37-R39 - 1k smd0805

    Reply

  • Hi, I downloaded Code, I want to upload under ATmega328, but I have two files *.hex and *.bin. Should I just upload the hex? Is the *.bin also as an eeprom ?

    Nov 23,20221 Comments
    John John Vu 2022-12-04 16:39:20Reply

    Hi! These files are the same firmware, for different programmers.

    Reply

  • What is the value of capacitor C1?

    Jan 15,20221 Comments
    John John Vu 2022-01-15 22:46:11Reply

    C1 can not be installed. Either install 100pF.

    Reply

  • need a gerber file

    Apr 02,20210 Comments
    Reply
VOTING 1 votes
VOTE NOW !
  • 1 USER VOTES
5.00
  • YOUR VOTE 0.00 0.00
Mike_Ho
Engineer
  • 5
    design
  • 5
    usability
  • 5
    creativity
  • 5
    content
5.00

More by John John Vu

You may also like