Low Power Continuity Tester
Low Power Continuity Tester
Board Size 50.5mm x 20mm,
Low power : Should run a decent amount on time on a single CR2032 cell.
Fully featured :
Low voltage continuity test mode : Compliance voltage < 0.5v, low current.
Inverse continuity mode : Beep if continuity is broken.
Both modes with "latching" glitch capture: start beeping immediately and keep beeping for at least a split second.
Diode test mode : Short beep on forward voltage within diode drop (0.1-0.7v), continuous beep on short circuit.
Simple to use : no power switch, turn on by touching probes, mode switch with a single button.
Low cost
Low Power Continuity Tester is Jose Ignacio Romero project
for more details please visit :
https://hackaday.io/project/8467-low-power-continuity-tester#j-discussions-title
Low Power Continuity Tester
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(0)
More by pohokanapoe MIV
-
External Dual VR Conditioner
External dual channel signal conditioner based on Maxim MAX9926, for use with VR crankshaft and/or c...
-
Dual VR Conditioner Adapter
Adapter for Speeduino Dual VR Conditioner ModuleSchematic :TOP SIDE :BOTTOM SIDE :BOARD DIMENSIONS :...
-
Dual VR Conditioner (Mini)
Dual VR Conditioner v3.x (mini size) for SpeeduinoA plug in module to allow your ECU to condition th...
-
MSOP-8 to DIP-8 Adapter
MSOP-8 to DIP-8 AdapterBoard Size 11mm x 11mmAttention : Don't populate MSOP-8 with thermal/exposed ...
-
SOIC-8 to DIP-8 Adapter
Standard SOIC-8 to DIP-8 AdapterBoard size 11mm x 11mmSOIC-8DIP-8
-
Dual VR Conditioner + Regulator
Dual VR Conditioner with optional 5V Voltage RegulatorI change some THT to SMT package and add capac...
-
Low Power Continuity Tester
Low Power Continuity TesterBoard Size 50.5mm x 20mm,Low power : Should run a decent amount on time o...
-
Tiny Remote
Tiny Remote - IR Remote Control based on ATtiny13A v1.1 by Stefan WagnerBoard size 43x94mm, I'm usin...
-
Dual VR Conditioner v3.x for Speeduino
A plug in module to allow your ECU to condition the AC signal from a VR Crank/Cam sensor to DC for y...
-
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
154 1 1 -
-
