|
EagleAutodesk
|
|
|
|
PiSCSI softwarePiSCSI
|
PiSCSI 'Drive'
Old SCSI hard drives and cd-rom drives are at the end of there life and failing .
They are not being made anymore , so what is the Retro computer enthusiast to do ?
Use the PiSCSI software on a Raspberry Pi to emulate all sorts of SCSI devices.
The PiSCSI software allows several devices or drives to be emulated at the same time!!
This interface allows the connection of a Raspberry Pi to the SCSI bus via a 50pin IDC connector and fits in a 3.5" Hard Drive space.
Please note :- There is NO PARITY on this board.
To give the full required space above the board the capacitors ( C1 , C2 , C3 ) and the 2 10k resistor networks ( RN1 , RN2 ) must be layed flat on the board .
RN3 , RN4 , RN5 and RN6 are OPTIONAL and only required if TERMINATION is required .
The PiSCSI software classifies this board as STANDARD for compiling .
For full build details please see my website https://levosretrocomputerprojects.co.uk/index.php/piscsi/piscsi-drive
PiSCSI 'Drive'
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(3)
- Likes(18)
- 2 USER VOTES
- YOUR VOTE 0.00 0.00
-
7design
-
6usability
-
7creativity
-
6content
-
10design
-
10usability
-
10creativity
-
10content
More by Alan Leverett
-
A500 IDE/Flop
The Idea for this project came from my building of a Spitfire500 accelerator .The Spitfire500 is a 1...
-
PiSCSI 'Drive'
Old SCSI hard drives and cd-rom drives are at the end of there life and failing .They are not being ...
-
RaSCSI Target Board
RaSCSI Target BoardThis is a target board for use with the Raspberry-Pi and the RaSCSI project .Aso ...
-
C64-Keyboard
I can confirm that the project is now fully working with either PS/2 or 5pin din connector and works...
-
DIY Cart+8
A DIY Cartridge for the VECTREX gaming system.Easy to use selection ( no link settings ) .This one i...
-
DIYCart+32
A DIY Cartridge for the VECTREX gaming system.Easy to use selection ( no link settings ) .This one i...
-
ZX81-PERIPHERAL-SUPPLY-PCB
A power supply and breakout board for ZX81 peripherals.Full details on my website.http://www.levosre...
-
ANanoMouse
Welcome to the ANanoMouse Page.Here we will create an interface for the AMIGA to use ps/2 optical a...
-
C64 ZaxxDual
While working on a project to replace the PLA in one of my Commodore64's I came across the fact that...
-
C64 PLA to ROM adapter
I have been looking at this project for a while and there are several boards around , however nobody...
-
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
153 1 1 -
-
