30-PIN SIMM with EDO-2-FPM Mod
This memory PCB allows you to create high capacity 4MB SIMM modules for older PCs, Macs, and other vintage computers.
With a few alterations to the original schematics, this PCB allows you to configure EDO memory chips to behave like FPM chips.
Therefore, you can use EDO chips on older hardware that only supports FPM memory.
The original schematics were taken from UpLateGeek GitHub.
Configuration:
"DEFAULT" follows the original schematics from UpLateGeek (supports FPM memory)
"EDO 2 FPM" changes the schematics to configure EDO memory chips to act like FPM modules (supports EDO and FPM memory)
Cheers,
BitsUndBolts
30-PIN SIMM with EDO-2-FPM Mod
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(19)
More by BitsUndBolts BitsUndBolts
-
16MB (2x 16Mx4bit +3.3V) SIMM PCBs with dual power supply
This PCB allows you to build the highest capacity 30-pin SIMM modules for use in vintage hardware li...
-
-5V Mod for ATX Power Supplies
This little PCB is creating the -5V power rail from the -12V rail.Some older ISA cards require the -...
-
30-PIN SIMM with EDO-2-FPM Mod
This memory PCB allows you to create high capacity 4MB SIMM modules for older PCs, Macs, and other v...
-
3dfx Voodoo Memory Expansion Board - Rev 1.1
The PCBs are used to clip on the Guillemot MAXI Gamer 3D Voodoo Graphics Accelerator.Usual memory si...
-
3dfx Voodoo Memory Expansion Board - Rev 1.0
The PCBs are used to clip on the Guillemot MAXI Gamer 3D Voodoo Graphics Accelerator.Usual memory si...
-
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
154 1 1 -
-
