|
Autodesk Fusion 360Autodesk
|
Amiga 1200 keyboard A1200.net keyboard mounting parts
If building the Amiga 1200 keyboard and you have an A1200.net case for your Amiga, these are the supports that mount the keyboard PCB.
There is nothing very special about these parts, no threaded inserts, no special materials required, I used PETG, but PLA or resin would probably be fine too.
Once you have located the wedge-shaped parts correctly on the front of the PCB it will be easier next time if you attach them with a little bit of double-sided tape, or else you will have to hold it in place every time you put the keyboard in the case.
Amiga 1200 keyboard A1200.net keyboard mounting parts
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(1)
More by Adam Eberbach
-
Atari 800 side panel for Sophia 2 with HDMI, audio, button
This side plate allows you to mount a PCB with HDMI, audio and a switch inside your Atari 800, it is...
-
VESA mount for Siglent SDS8xx oscilloscope
Divided to fit on a regular-sized printer, this VESA mount fits the Siglent SDS8xx oscilloscopes.fee...
-
Amiga 1200 keyboard A1200.net keyboard mounting parts
If building the Amiga 1200 keyboard and you have an A1200.net case for your Amiga, these are the sup...
-
Amiga 1200 Keyboard for MX switches
I was an Amiga user back in the day... had a 1000, then a 2500 (then sadly the demands of work requi...
-
Atari Sophia 2 video HDMI/stereo board
If you have a Sophia 2 in your 8-bit Atari then you may prefer HDMI to DVI. This board does that, re...
-
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
154 1 1 -
-
