|
OnShapeOnShape
|
E3D Revo Heatsink Adapter for the Sovol SV08
This heatsink will allow you to install an E3D Revo hot-end (40W or 60W) to your Sovol SV08, using the original fan and tool head mounting. It mimics the exact same length, as well, so you shouldn't even need to adjust Z-Offset too much.
Please note that this final version has not been tested yet - it's possible you will need to bore out the very top hole where the filament path goes and report back, but it's no big deal to do so with a standard drill bit.
Once someone reports back, I will update this description letting you know that it is ready to go.
E3D Revo Heatsink Adapter for the Sovol SV08
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(11)
- Likes(3)
More by Engineer
-
-
-
kmMiniSchield MIDI I/O - IN/OUT/THROUGH MIDI extension for kmMidiMini
111 0 0 -
DIY Laser Power Meter with Arduino
162 0 2 -
-
Box & Bolt, 3D Printed Cardboard Crafting Tools
155 0 2 -
A DIY Soldering Station Perfect for Learning (Floppy Soldering Station 3.0)
555 0 2
