EP2C5T144 FPGA HDMI Core
This board can be used to generate basic HDMI video. (576p, 576i, 480p, 480i)
I was planning to use this board as a Core Module for my other projects requiring HDMI Output.
FPGA Programming Pins are routed to the pins. Only 3.3V supply is required, 1.2V regulator is on board.
Referance Clock signal must be supplied to the board. There is no soc on the board. Normally if a video decoder is used in the project, 27MHz LLC clock signal should be routed to this board.
Other unused pins might be used to transfer 8-bit ITU-R BT.656 video data to the FPGA. HDMI output connector is populated on the board.
EP2C5T144 FPGA HDMI Core
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
ESP32-S3 4.3inch Capacitive Touch Display Development Board, 800×480, 5-point Touch, 32-bit LX7 Dual-core Processor
BUY NOW
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(0)
- Likes(5)
Log in to post comments.
More by eins tronix
-
-
Commodore 64 1541-II 1581 Floppy Disk Drive C64 Power Supply Unit USB-C 5V 12V DIN connector 5.25
436 1 4 -
-
-
-
-
-
-
Modifying a Hotplate to a Reflow Solder Station
1289 1 6 -
MPL3115A2 Barometric Pressure, Altitude, and Temperature Sensor
724 0 1 -
