GALAKSIJA PLUS
GALAKSIJA PLUS / ГАЛАКСИЯ ПЛЮС
Galaksija Plus was an improved version of Galaksija, with 256 X 208 monochrome graphics mode, 3 - voice sound based on AY-3-8910 and 48 KB RAM.
The hardware of Galaksija Plus was created by Nenad Dunyich and software by Milan Tadich in 1985. The goal was to enhance original Galaksija while keeping the original goal of keeping things inexpensive and simple for the constructor.
Continuing to use Static RAM in Galaksija Plus would have significantly increased the cost, so designers decided to switch to dynamic, built out of 4416 chips. Larger memory prompted the need for faster cassette tape data recording rate, which was increased to 1200 bit / s by modifying another piece of firmware.
Having enough memory to store the bit map and since Galaksija's own CPU directly drove the video signal, video generation hardware did not have to change significantly. Video generation routine was modified to take the raw video data from the new video memory instead of relying on character set ROMs. Some games for original Galaksija used to do a similar trick, albeit in a limited fashion due to restrictive memory capacity.
The final hardware upgrade was addition of AY-3-8910 sound - generation chip, providing contemporary - standard sound to Galaksija without the need to use tricks such as with the cassette tape port.
Galaksija Plus featured new software additions: Graphic primitives in BASIC language - commands to draw lines, boxes, circles, other graphic primitives as well as drawing text on graphical screen with different font. Additional firmware (ROM C) also featured Full Screen Source Editor and soft scrolling.
SPECIFICATIONS
- ROM: additional ROM "C" or "3" - 2 KB (in 2716 EPROM) - additional firmware specific to Galaksija Plus (e.g. graphics mode drivers and handling);
- RAM: 48 KB of 4416 dynamic RAM, 46 KB accessible;
- Storage media: cassette tape, recording at either 280 or 1200 bit / s rate;
- Text mode 32 X 16 characters, monochrome;
- Graphics mode: 256 X 208;
- Sound: 3 - channels + white noise provided by AY-3-8910;
- I / O ports: two 8 - bit parallel ports (e.g. printer and general port).
site project:
http://www.spetsialist-mx.ru/Galaksija/index6.html
GALAKSIJA PLUS
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(1)
- astrodoggie Jul 12,2023
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Alexiev
- Afterburner - GAL chip programmer for Arduino This is a GAL IC programmer software that allows to program GAL IC chips from various manfucaturers....
- ATFBlast - ATF16V8, GAL16V8, ATF22V10 and GAL22V10 chips programmer ATF16V8, GAL16V8, ATF22V10 and GAL22V10 chips programmer.This is custom PCB variant of ATFBlast proj...
- ArduTrx Attenuator or Dummy load IntroductionTo test the ArduTrx or transceivers in general a dummy load is a handy device (https://e...
- ArduTrx Open Source Hamradio Transceiver for Arduino The ArdTrx project consists of two parts: the ArduTrx shield and the software. Both parts can be use...
- MonochromeVGA MonochromeVGA is a product to enjoy the charm of those monochrome monitors of the time but in the cu...
- NES64 Make Your Own Joystick The NES64 is a replacement PCB for use in an existing controller for the Nintendo Entertainment Syst...
- AY-3-8912 Emulator (AVR-AY) AY-3-8912 Emulator (AVR-AY)used in many old computers as Amstrad CPC, Oric-1, Colour Genie, Elektor ...
- 4116 dram tester project by : Muttley Black
- Covox Speech Thing Sound Card SMD version he Covox Speech Thing is an external audio device attached to the computer to output digital sound. ...
- Covox Speech Thing Sound Card for Parallel Port LPT with resistor DAC - Short version Covox Speech Thing Sound Card for Parallel Port LPT with resistor DAC - Short verionThe short versio...
- Covox Speech Thing Sound Card for Parallel Port LPT with resistor DAC - Long version Instead of using two types of resistors with 1/2 relation, I just used all the same types, but doub...
- 8bit ISA IBM XT, 286, 386, 486 Analog input card - Game control adapter Recreation of IBM Analog input card 99.1 mm* 79.4 mmAn 8-bit ISA card with gameport. It avoids the...
- Customizable crystal oscillators Half size - can style Customizable crystal oscillators Full size - can style The ClockInACan is a small circuit board that...
- Customizable crystal oscillators Full size - can style The ClockInACan is a small circuit board that is the same size as the oscillator and duplicates the...
- OCTOBAND – 8 Band PA+LPF Board For uSDX TriBand (An All Mode HF QRP Transceiver) OCTOBAND – 8 Band PA+LPF Board For uSDX TriBand (An All Mode HF QRP Transceiver) - designed by BAR...
- C64 Video Enhancement, Analog Only C64 Video Enhancement, Analog OnlyThe analog circuit that was just meant as a simple replacement to ...
- Raspberry Pi 360K floppy drive Project by Scott BakerRaspbian is not a real-time OS, and the FDC is absolutely intolerant of bytes ...
- APPLE II ProDOS ROM Drive This is a peripheral card for the Apple ][ series computers that acts as a read-only solid state dis...
-
-
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
154 1 1 -
-