|
|
HDMI Edge Female Connector |
x 1 | |
|
|
6 pin 2.54mm Screw Terminal Block |
x 2 | |
|
|
3 pin 2.54mm Male Header |
x 1 | |
|
|
6pin JST ZH 1.5mm pitch connector |
x 1 |
ISS Mimic - HDMI Breakout Board
ISS Mimic is a project to create a 1% scale 3d-printed model of the International Space Station (ISS) that utilizes hobbyist electronic equipment to rotate all of the moving joints on the ISS using actual data transmitted from the ISS in real time. Our objective is to enable anyone in the world to visualize exactly what the ISS is doing at any time in order to spread public spaceflight awareness and further STEM engagement.
This is the HDMI breakout board used to split out the signals for use by the SARJ/TRRJ/and BGA motors.
Check out our project: https://www.youtube.com/watch?v=W9iZBjzOEEQ
https://github.com/ISS-Mimic/Mimic
https://discord.gg/zPKyE6hBSe
ISS Mimic - HDMI Breakout Board
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(3)
More by Sam Treadgold
-
ISS Mimic - Motor Breakout Board
ISS Mimic is a project to create a 1% scale 3d-printed model of the International Space Station (ISS...
-
ISS Mimic - HDMI Shield
ISS Mimic is a project to create a 1% scale 3d-printed model of the International Space Station (ISS...
-
ISS Mimic - HDMI Breakout Board
ISS Mimic is a project to create a 1% scale 3d-printed model of the International Space Station (ISS...
-
-
Helium IoT Network Sensor Development board | H2S-Dev V1.2
120 0 0 -
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
183 1 1
