Led lamp T10 or W5W for car
### DESCRIPTION
Car lamp t10 or W5W. Of the features - no polarity, installation by either side, added a resistor removing flicker off the lamp. NO CANBUS.
allows you to solder the LEDs 2835 and 5730/5630
The rated current is better to do 20mA, which will achieve a brightness comparable to an incandescent lamp, but without heating.
It is necessary to make high-quality LEDs LG, Samsung, Seoul
Instead of resistors it is possible to install the driver NSI45020.
### TECHNICAL DETAILS / COMPONENTS
Constant current 20ma/40ma:
- 6pcs LED 2835 or 5630/5730
- 2/4pcs NSI45020 driver
- 1pcs 0805 resistor 3KΩ
- 2pcs BAT54C diod or analog
Chip version:
- 6pcs LED 2835 or 5630/5730
- 2/4pcs 0805 resistor 300Ω (for white, blue, green) (~20/40ma)
(2/4 pcs 0805 resistor 560Ω (for red, orange) (~20/40ma)
- 1pcs 0805 resistor 3KΩ
- 2pcs BAT54C diod or analog
Led lamp T10 or W5W for car
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(4)
More by Максим Maxbolt
-
Christmas toy from MaX
Simple PCB for a Christmas moodMarry Christmas!
-
Christmas tree 2019 NeoPixels WS2812B Attiny13
### DESCRIPTIONChristmas tree as a decoration of the desktop, can be connected via USB power. Pleasa...
-
Led lamp T10 or W5W for car
### DESCRIPTIONCar lamp t10 or W5W. Of the features - no polarity, installation by either side, adde...
-
TP4056 Linear Li-ion cnarger 3A or othrer (0,4A - 4A)
### DESCRIPTIONThis board is designed to charge 1 li-ion battery with 3A current performed on TP4056...
-
Soft start for LED (max current 2A) or Arduino load control (max current 2A)
### DESCRIPTIONBoard for soft-srart led strip 12V or 24VHave 1 pin control (Cntr) when positive volt...
-
Test board 16-channel led driver DM631 (12bit PWM control)
### DESCRIPTIONA test card for debugging the firmware on Arduino or learning the capabilities of thi...
-
-
Helium IoT Network Sensor Development board | H2S-Dev V1.2
116 0 0 -
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
181 1 1
