Tools, APP Software Used etc.
|
KiCADKicad
|
Description
Michelle Special Education Edition
A simplified (completely through-hole) version of the DIY Perks USB Microphone preamp using the THAT1512.
See here for the Original Project
This can be married to one of my other PCBs (Ubuntu or Chimera) or used in isolation as an upgrade to the project. All resistors are 1/8th or 1/4 watt metal-film, 1% or better. All components except for the three 22 uF capacitor are identical to the original. The three 22uF NP electrolytics have been replaced with longer-lasting MLCC versions.
The only addition/change made to the original schematic is a single LED and current limiting resistor.
May 24,2024
135 views
Michelle Special Education Edition
A version of the DIY Perks USB C Microphone Pre-amp with all through-hole components.
135
0
0
Published: May 24,2024
PCBWay Donate 10% cost To Author
Under the
Attribution-ShareAlike (CC BY-SA)
License.
- Comments(0)
- Likes(0)
Upload photo
You can only upload 5 files in total. Each file cannot exceed 2MB. Supports JPG, JPEG, GIF, PNG, BMP
0 / 10000
More by Engineer
-
Michelle Special Education Edition
A simplified (completely through-hole) version of the DIY Perks USB Microphone preamp using the THAT...
-
Michelle Bob
This is a partially modified PCB based on the circuit designed by Matthew Perks (DIYPerks.com) for t...
-
Hathor - SGTL5000 audio breakout for ESP32
DANGER: this board is preliminary and untested as of this writing!Datasheet for the IC: SGTL5000.pdf...
-
Minerva: multiple JFET carrier
They don't come a lot simpler than this.Imagine you want to use the JLI-2555 microphone capsule or o...
-
Hesychia: silence is golden
R1, C1 and D1 form a slow-start, fast response mass-energy store for large ripples. The actual value...
You may also like
-
-
-
kmMiniSchield MIDI I/O - IN/OUT/THROUGH MIDI extension for kmMidiMini
125 0 0 -
DIY Laser Power Meter with Arduino
182 0 2 -
-
Box & Bolt, 3D Printed Cardboard Crafting Tools
165 0 2
