Joshua Levesque
CANADA • + Follow
Components
|
|
ST25TA02KB-DC6H5STMicroelectronics
|
x 1 |
Tools, APP Software Used etc.
|
Altium DesignerAltium Designer
|
Description
NFC Business Card
Uses ST25TA02KB-DC6H5 chip which is a bit of a pain to solder. I DO NOT RECOMMEND DOING THIS WITH AN IRON. You need either hot air or an oven to make this work well. There are pads for an led and a resistor that are not used. I was going to experiment with power harvesting, but never got the components in. Still works though, and very well.
MAKE SURE TO INCLUDE SOLDERMASK IN YOUR NFC CALCULATIONS!
Mar 31,2025
59 views
end-flag
NFC Business Card
This is a simple design for a PCB with an antenna on it for NFC. It can be programmed with your phone to your website and costs 50cents/card
59
1
0
Published: Mar 31,2025
Download Gerber file 1
BOM(Bill of materials)
PCBWay Donate 10% cost To Author
Only PCB
PCB+Assembly
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Under the
Attribution-NonCommercial (CC BY-NC)
License.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
ESP32-S3 4.3inch Capacitive Touch Display Development Board, 800×480, 5-point Touch, 32-bit LX7 Dual-core Processor
BUY NOW
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(0)
- Likes(1)
Log in to post comments.
Upload photo
0 / 10000
More by Joshua Levesque
You may also like
-
-
-
Commodore 64 1541-II 1581 Floppy Disk Drive C64 Power Supply Unit USB-C 5V 12V DIN connector 5.25
474 1 4 -
-
-
-
-
-
-
-
Modifying a Hotplate to a Reflow Solder Station
1325 1 6
