Nintendo Gamecube WASP Fusion connector
In this project I'm using a WASP Fusion FPGA board to mimic a Gamecube's disk drive. The goal is to eliminate the need for disks when playing games instead the data will be saved on an SD card for the FPGA to read and delivering requested data to the motherboard. Memory offsets for choosing games are establish through SWISS software. SD card is formatted to FAT32 with the maximum allowable size being 64 GB. The interface board I developed uses a stripped P9 connector from the disk drive to plug into the female socket located on the motherboard. This nonintrusive design allows for easy plug ability and no need for tampering with the motherboard. The interface board also has a 3.3V regulator to power the WASP Fusion and a micro SD card slot.
Project Link: https://timee1994.weebly.com/gamecube-virtual-disk-drive.html
Nintendo Gamecube WASP Fusion connector
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
ESP32-S3 4.3inch Capacitive Touch Display Development Board, 800×480, 5-point Touch, 32-bit LX7 Dual-core Processor
BUY NOW
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(0)
- Likes(2)
Log in to post comments.
More by Engineer
-
Modifying a Hotplate to a Reflow Solder Station
176 0 2 -
MPL3115A2 Barometric Pressure, Altitude, and Temperature Sensor
128 0 1 -
-
-
V2 Commodore AMIGA USB-C Power Sink Delivery High Efficiency Supply Triple Output 5V ±12V OLED display ATARI compatible shark 100W
377 4 1 -
How to measure weight with Load Cell and HX711
422 0 3 -
-
Instrumentation Input, high impedance with 16 bit 1MSPS ADC for SPI
531 0 0
