|
KiCADKicad
|
PiStorm Tester ZZ9 Plural Z Alpha
PiStorm Tester is a PCB that exposes all the IO's of the 68000 DIP64 socket that PiStorm uses. There are status LED's on all the control/Address/Data Bus lines to easily see if a single line is stuck high or low. each IO is also broken out to a header for easy connection to an external microcontroller such as an arduino for more accurate analysis of the outputs, or for pulling inputs high or low as required. where the line is either an input or bi-directional (such as the Data bus) the headers have a handy VCC and GND rail adjacent for easy jumpering. Combined with testing programs on the pi such as buptest, it becomes easy to narrw down individual faults such as unsoldered or broken individual flip-flops.
For the complete BOM, instructions and testing code that compliments the board, find the project page at https://github.com/abrugsch/PistormTester
Parts:
60x 0603 LED of your choice of colours.
15x 4x0402 1KOhm resistor arrays
1x 3225 8MHz Oscillator (Shenzhen SCTF Elec S3D8.000000A20F30T recommended. Part nr. C387338 from lcsc.com
1x 0.1uF 0402 capacitor
1x 15uF 0402 capacitor.
1x DIP-64 socket. (TRY NOT TO USE A MACHINED PIN SOCKET.leaf-wipe or ZIF is the bast for this board)
Header pins or socket strips for the test points
PiStorm Tester ZZ9 Plural Z Alpha
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(3)
- Jörgen Olmats Dec 31,2022
- Johnny RetroFletch Jul 27,2021
- (DIY) C64iSTANBUL Jul 21,2021
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by Al The Dude
- PiStorm Tester ZZ9 Plural Z Alpha PiStorm Tester is a PCB that exposes all the IO's of the 68000 DIP64 socket that PiStorm uses. There...
- BLTouch-ender3-minimal DescriptionA minimal breakout Pin 27 for the Ender 3 3D printer to use the BLTouch auto leveler with...
- BLTouch for Ender 3 MINIMAL breakout **********IMPORTANT*********** new revison availableIf the cable that comes with your BLTouch has a ...
- Ender 3 BLTouch adapter **********IMPORTANT*********** (Do not order, there's a new revison available ( here )- unless ...
-
-
-
kmMiniSchield MIDI I/O - IN/OUT/THROUGH MIDI extension for kmMidiMini
123 0 0 -
DIY Laser Power Meter with Arduino
172 0 2 -
-
-
Box & Bolt, 3D Printed Cardboard Crafting Tools
162 0 2 -