Pumpkin Badge V1
### DESCRIPTION
Just a fun little board for Halloween 2018. It runs on a PIC12F1572 (though I'm sure a 12F683 could run it as well) and supports both DIP8 and SOIC8 packages.
This is really just intended to be a fun little badge, so don't expect an overly practical item.
Made by Gadorach, 2018.
### TECHNICAL DETAILS / COMPONENTS
BOM:
17x 0603 LED
2x EXB2HV 100 ohm RA
1x PIC12F1572 (DIP8 or SOIC8)
1x PCA9685PW
1x 500mA+ Diode
1x 100nF Capacitor
1x BC3AAAPC Battery Holder
4x 0805 10K ohm
1x 0805 220 ohm
1x 6x6mm Tact Switch
1x 6-pin Header
3x AAA Battery
You'll also need a PICKIT3 Programmer, or similar means by which to program the 12F1572 microcontroller.
I'll be posting the program for this device in a week or so, but it's very simple. Feel free to write your own based on the schematic.
Look for any updates on Twitter at @Gadorach
https://twitter.com/Gadorach
Pumpkin Badge V1
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
ESP32-S3 4.3inch Capacitive Touch Display Development Board, 800×480, 5-point Touch, 32-bit LX7 Dual-core Processor
BUY NOW
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(0)
- Likes(1)
Log in to post comments.
More by Gadorach
-
Commodore 64 1541-II Floppy Disk Drive C64 Power Supply Unit USB-C 5V 12V DIN connector 5.25
56 0 1 -
Easy to print simple stacking organizer with drawers
23 0 0 -
-
-
Modifying a Hotplate to a Reflow Solder Station
1059 1 6 -
MPL3115A2 Barometric Pressure, Altitude, and Temperature Sensor
578 0 1 -
-
-
V2 Commodore AMIGA USB-C Power Sink Delivery High Efficiency Supply Triple Output 5V ±12V OLED display ATARI compatible shark 100W
1337 4 3
