|
FreeCADFree Software Foundation, Inc.
|
Sharp X1 Twin Dual Gotek Caddy
This caddy mounts in place of the original floppy drive(s) using 2 of the 4 original mounts and screws. The screw holes in the mounting wings are slightly slotted to allow for minor adjustments in alignment with the front panel. The model is designed with a snug fit into the front openings, so use care when first attempting to install. There are no extra internal braces, but I did not have any issues with warping. I did include a good amount of large fillets for reinforcement in many areas.
I suggest printing in black resin.
Sharp X1 Twin Dual Gotek Caddy
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
- Comments(0)
- Likes(0)
- 0 USER VOTES
- YOUR VOTE 0.00 0.00
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
More by OMPea Retro
- Sharp MZ-700 Keyboard Key Post This is a replacement keyboard key post for the Sharp MZ-700 series of computers.Check for a smooth ...
- Sharp X1 Turbo Gotek Caddy This caddy mounts in place of the original floppy drive on a Sharp X1 Turbo allowing you to mount 1 ...
- Sharp X1 Twin Dual Gotek Caddy This caddy mounts in place of the original floppy drive(s) using 2 of the 4 original mounts and scre...
-
-
Helium IoT Network Sensor Development board | H2S-Dev V1.2
95 0 0 -
-
-
-
-
-
3D printed Enclosure Backplate for Riden RD60xx power supplies
178 1 1