Simple single knob clean boost pedal circuit
I needed a boost for recording some bass guitar and stumpled upon a circuit by jer00n.nl
After some quick prototype i had a working clean boost pedal.
I decided i wanted a more fancy solution than just a breadboard with the circuit, so i designed this pcb in KiCad and got it made at PBCWay.
The original circuit by jer00n.nl uses a 220k resistor in place af my 470k one.
The 470k one should push the circuit from 10db to around 14db.
This is my first project so there is still some kinks, like the solder mask is only on the front of the board, and the -9V should really just be labled GND.
Enjoy!
>link to larger schematic https://i.imgur.com/VUkLksL.png
Simple single knob clean boost pedal circuit
*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
ESP32-S3 4.3inch Capacitive Touch Display Development Board, 800×480, 5-point Touch, 32-bit LX7 Dual-core Processor
BUY NOW
Raspberry Pi 5 7 Inch Touch Screen IPS 1024x600 HD LCD HDMI-compatible Display for RPI 4B 3B+ OPI 5 AIDA64 PC Secondary Screen（Without Speaker）
BUY NOW
- Comments(0)
- Likes(3)
Log in to post comments.
More by Mikkel Steen Nielsen
-
Commodore 64 1541-II 1581 Floppy Disk Drive C64 Power Supply Unit USB-C 5V 12V DIN connector 5.25
164 1 3 -
Easy to print simple stacking organizer with drawers
87 0 0 -
-
-
Modifying a Hotplate to a Reflow Solder Station
1137 1 6 -
MPL3115A2 Barometric Pressure, Altitude, and Temperature Sensor
638 0 1 -
-
-
V2 Commodore AMIGA USB-C Power Sink Delivery High Efficiency Supply Triple Output 5V ±12V OLED display ATARI compatible shark 100W
1439 4 3
