Description

Single OpAmp Setup Non-Inverting_2023-09-06

A simple Inverting OpAmp board designed to allow you to play with an OpAmp and learn more about it. Plug in the OpAmp you want to test and you can easily adjust the gain or even offset and quickly check how the device is functioning.

Handy if you just starting out or you have a new device and you wish to experiment. You might want to see how it reacts to signal strength and frequency of the input vs. the output.

Lots of test points and gain controls to emulate the feedback and input resistors.

All you need is a simple battery - don't use a switch mode supply as they are extremely noisy and you'll amplify that noise along with the input signal !

Download Gerbers

Sep 28,2023

513 views

end-flag

Single OpAmp Setup Non-Inverting_2023-09-06

2 Layers PCB 60 x 60 mm FR-4, 1.6 mm, 1, HASL with lead, Green Solder Mask, White silkscreen

You too can play with your OpAmps in an inverting setup.

513

Published: Sep 28,2023

Download Gerber file 1

PCBWay Donate 10% cost To Author

Add to cart

*PCBWay community is a sharing platform. We are not responsible for any design issues and parameter issues (board thickness, surface finish, etc.) you choose.

Copy this HTML into your page to embed a link to order this shared project

Copy